ccna question paper

ccna question paper

Failover unit Primary There is also a change of 0X2102. This is very simple so not too much to say. The other two SUP7LEs can be activated normally. boot system flash bootflash:cat4500e-universal.SPA.03.02.03.SG.150-2.SG3.bin This host: Primary - Active Installing licenses from "bootflash:F〇X1509GTJU_20111127185652223.lic" ip route 0.0.0.0 0.0.0.0 12.1.1.1 Sup7_E#license install bootflash:FOX1509GTJU_20111127185652223.lic interface G0/1 There are now four 4507R+E chassis, two dual-engine SUP7Es, and two single-engine SUP7LEs. Now you need to upgrade IOS to the latest and activate IP License for the BASE version. Initial configuration is good. Do VSS configuration. username CISCO privilege 15 password 0 cisco failover key cisco Failover unit Primary Int ethernet0/0 access-list 101 permit ip any any failover lan interface failover Ethernet0/2 At the time of design, the most important thing is simple, efficient and there must be some reservations. Sometimes customers can not fully propose themselves. The business needs this requires designers to think about whether the business flow in the next five or ten years can meet the development needs of customers. 4507B(config)#config-register 0x2102 The above architecture is Cisco's most traditional. Of course, the most stable and classic, and my personal favorite architecture,ccna question paper, It’s basically can see such architecture in all books. Sure, the traditional architectural advantage is stability but the shortcomings are also obvious that not suitable for the current situation of big data traffic. Therefore, it is also a backward structure. int Ethernet0/1 ip dhcp pool ccna License Level: entservices Type: Permanent Then, I started looking for documents on the Internet to see if there were any solutions. The results were searched online and only two are introducing this upgrade but the version does not encounter such a problem at all. I also read a piece of text that puts me under pressure: This is equivalent to a big firewall. People in the exchange can freely enter and exit but we can not enter when you want to enter. When entering, it must be released explicitly. For example, we have made an appointment in advance so we can enter the park. However, we can't enter the machine room when entering the park. This is equivalent to the security level of the firewall. You have to go to the construction of Building 11. It is also necessary to release it clearly and pass the security check. Therefore,you can't be between different levels Mutual access. As you can see, the design of such a data center is quite tacit with the concept of a firewall. It is also a design with a high level of security. If you encounter security in the data center, you can consider such a design project.