350-501 dumps

350-501 dumps

5.Last step are to check the commands to enable LLDP per interface and disable per device. Feel free to ignore the switchport command if you are using a lower-end switch (the above output was from a Cat6K switch). This configuration can be validated via the show interfaces [name] switchport command, as illustrated in the following output: Auto Negotiation - not supported Verifying all the routing protocols that advertise that specific prefix (including static routing) Challenge 2 – Trunking, VLANs and DTP Lab Day 13 Tasks Last update from 10.1.1.2 on Ethernet0/0.1, 00:00:15 ago Routing Descriptor Blocks: Cisco routers use the longest prefix match rule when determining which of the routes placed into the routing table should be used to forward traffic to a destination network or node. Longer, or more specific,350-501 dumps, routing table entries are preferred over less specific entries, such as summary addresses, when determining which entry to use to route traffic to the intended destination network or node. Turn it off with the no auto-summary command: Switch-1(config)#interface GigabitEthernet0/2 Switch-1(config-if)#switchport port-security Since a router will always prefer a more specific route, any traffic destined for 192.168.1.10 will use the more specific host route and the router will not consider the /24 routes to forward this traffic. Now, any and all traffic coming from the Branch Router destined for 192.168.1.10 will traverse Low Latency Networks. Link State routing protocols operate by sending Link State Advertisements or Link State Packets to all other routers within the same area. These packets include information on attached interfaces, metrics, and other variables. As the routers accumulate this information, they run the SPF algorithm and calculate the shortest (best) path to each router and destination network. Using the received Link State information, routers build the Link State Database (LSDB). When the LSDBs of two neighboring routers are synchronized, the routers are said to be adjacent.